2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 101Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 101

4On the coolant temperature switch, allow the water to cool, and when the temperature is within temperature range of 107-113
the black wire from the fan connector to groundThe fan should operate Fan Motor NOTE: The ignition switch must be in the
ON position VOLTAGE (Main Harness Connector to Fan Motor) ! CAUTION Care should be taken to keep clear of the fan blades
1Set the meter selector to the DC Voltage position2Connect the red tester lead to the blackred wire (the black 2-prong at
the fan motor); then connect the black tester lead to ground3The meter must show battery voltageNOTE: If the meter shows
no battery voltage, troubleshoot the battery, fuse, motor, or the main wiring harnessNOTE: If the meter shows battery voltage,
the main wiring harness is goodThe connector should be checked for resistance Power Distribution Module The fuses are located
in power distribution module under the driver's seatIf there is any type of electrical system failure, always check the fuses