2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 102Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 102

2Set the meter selector to the DC Voltage position3Connect the black tester lead to ground4Using the red tester lead, contact
(with the wire removed); then connect the black tester lead to ground 2The meter reading must be within specification ! CAUTION
Always disconnect the battery when performing resistance tests to avoid damaging the multimeter Secondary Winding 1Set the
meter selector to the OHMS position2Connect the red tester lead to one spade end of the fuse; then connect the black tester
lead to the other spade end3The meter must show less than ohm resistanceIf the meter shows open, replace the fuseNOTE: Make
sure the fuses are returned to their proper position according to amperageRefer to the amperage listed under each fuse on
the power distribution module 1Connect the red tester lead to the high tension lead (with the plug cap removed); then connect
the black tester lead to ground2The meter reading must be within specificationNOTE: If the meter does not show as specified,