2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 103Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 103

2The meter reading must be within specificationNOTE: If the meter does not show as specified, replace the spark plug cap
wire from the coil2Connect the red tester lead to the primary wire; then connect the black tester lead to ground ! WARNING
Do not touch the primary wire with the ignition switch turned on or severe electrical shock will occur To replace speed sensor,
use the following procedure1Disconnect the three-wire connector from the speed sensor harness or from the speed sensor; then
remove the Allen-head cap screw securing the sensor to the sensor housing2Remove the sensor from the sensor housing accounting
for an O-ring 3Turn the ignition switch to the ON position4The meter must be within specification5With the test leads still
connected, crank the engine with the electric starter6The meter must show 300-450 DC volts Speed Sensor NOTE: Prior to testing
the speed sensor, inspect the three-wire connector on the speed sensor for contamination, broken pins, andor corrosionCD070