2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 104Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 104

Headlight Switch VOLTAGE 1Connect the red meter lead to the gray wire; then connect the black meter lead to the black wire2Turn
the red meter lead to the red wire; then connect the black meter lead to ground3Meter must show battery voltageNOTE: If the
meter shows no battery voltage, troubleshoot the main 30 amp fuse, the battery, or the main wiring harness 2WD4WD Selector
Switch VOLTAGE 4Connect the red meter lead to the redblack wire; then with the black lead grounded, turn the ignition switch
to the ON positionThe meter must show battery voltage5Connect the red meter lead to the yellowgreen wire; then with the black
lead grounded, turn the ignition switch to the START positionThe starter should engage and the meter must show battery voltageNOTE:
When the starter is engaged, battery voltage will be approximately 10.5 DC volts 1Connect the red meter lead to the gray
wire; then connect the black meter lead to the black wireTurn the ignition switch to the ON positionThe meter must show battery