2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 107Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 107

RESISTANCE (Charging Coil) 4The meter reading must be within specificationMagneto Coil (Source) ! CAUTION Always disconnect
reading must be within specificationRESISTANCE (Source Coil) REMOVING 1Disconnect the battery 1Set the meter selector to
the OHMS position2Connect the red tester lead to the yellow wire; then connect the black tester lead to the white wire3The
meter reading must be within specificationNOTE: If the meter shows other than specified in any resistance test, replace the
stator assembly ! CAUTION Always disconnect the negative battery cable from the battery first; then disconnect the positive
cable 2Remove the nut securing the positive cable to the starter; then remove the cable from the starter3Remove the two cap
screws securing the starter with ground wires to the crankcase; then remove the starterAccount for the wiring forms and an
O-ringINSTALLING PEAK VOLTAGE NOTE: All of the peak voltage tests should be made using the Fluke Model 73 Multimeter (pn
0644-191) with Peak Voltage Reading Adapter (pn 0644-307)If any other type of tester is used, readings may vary due to internal