2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 108Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 108

1Set the meter selector to the DC Voltage position2Connect the red tester lead to the starter terminal; then connect the
starter motor condition, andor ground connectionsNOTE: If the meter showed no battery voltage, inspect the main fuse, ground
connections, starter motor lead, battery voltage (at the battery), starter relay, or the neutral start relayPR297A Starter
Relay 1Remove the operator's seat; then using the multimeter set to the DC Voltage position, check the relay as follows2Connect
the red tester lead to the positive battery terminal; then connect the black tester lead to the starter cable connection
on the starter relayThe meter must show battery voltage 5Depress the starter button and observe the multimeterNOTE: If battery
voltage is indicated, replace the starter relayIf no voltage is indicated, proceed to Neutral Start Relay check CDI Unit
The CDI is located beneath the operator's seat near the batteryNOTE: The CDI unit is not serviceable componentIf the unit