2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 112Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 112

Drive System NOTE: Some photographs and illustrations used in this section are used for clarity purposes only and are not
lubricant Lockup: gear case lubricant loss or not filled, water contamination causing bearing seizure General Information
All gear cases are tagged beneath cover boltThis tag is marked with production date code, sequence code, and ratio codeAll
gear cases are 4.0:1 ratioThe die-cast aluminum housings have been assembled with thread-rolling screws (trilobular)When
assembling with these screws, start the screws carefully into the housing; then use the following torque valuesSize M6 (Torx
T-30 Recess) M8 (Torx T-40 Recess) Front Drive Actuator NOTE: The actuator is not serviceable componentIf it is defective,
it must be replacedNOTE: The actuator will operate only when the ignition switch is in the ON position New Housing 1.1-1.3
kg-m (8-9.5 ft-lb) 3.5-4.3 kg-m (25-31 ft-lb) Reassembled Housing 0.9-1.2 kg-m (6.5-9 ft-lb) 2.9-3.5 kg-m (21-25 ft-lb) TROUBLESHOOTING
If noise is heard from the gear case area, it can be difficult to locate andor diagnoseIf the noise is related to wheel speed,