2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 113Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 113

3Remove the mounting cap screw from above the actuator on the suspension side 3While holding the actuator firmly forward,
screw on the driveshaft side AG926 AG928 INSTALLING NOTE: It is important to tighten this cap screw while the others are
loose to ensure proper seating of the actuator 1Lubricate the O-ring on the actuator; then ensure that all mounting surfaces
are clean and free of debris2Align the actuator with the selector shaft and slide it forward onto the shaft taking care to
engage the cap screw in the slot of the front mounting tab 5Tighten the remaining cap screws; then connect the electrical