2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 118Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 118

4Install the input shaft into the pinion housing; then secure in the bearing with circlip Disassembling Pinion Gear NOTE:
existing cap screwsTighten to specificationsNOTE: If new gear case housing is being installed, tighten the cap screws to
3.5-4.3 kg-m (25-31 ft-lb) 2Using T-40 torx wrench, remove the cap screws securing the gear case coverAccount for and make
note of the ID tag location for assembling purposes 3Using plastic mallet, tap lightly to remove the differential coverAccount