2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 120Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 120

NOTE: If gears are being replaced, use the existing shimsThe numbers are scribed onto the gears: the ring gear has the number
and hammer, remove the pinion gear from the gear case housing Shimming Procedure Shim Selection 1Press bearings into bores
by outer ring to hard contact with seat2Install the lock collar and tighten to specifications; then stake the lock collar
edge approximately 1.5 mm (0.060 in into the lower oil channel 9Secure the pinion gear in bearing puller; then remove the
pinion bearing using pressAccount for collar and bearingCC891 3Note the following shim selections (shims are nominally 1.5