2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 123Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 123

Removing Needle Bearing NOTE: Removing the needle bearing is rarely necessaryAvoid removing the needle bearing unless the
2Using propane torch, heat the area surrounding the needle bearing to soften the LoctiteKX175A CC886 KX174A 11Making sure
the O-ring is properly positioned on the gear case housing, install the housing with existing hardwareAccount for the ID
tagTighten the cap screws to specificationsNOTE: Grease can be applied to the O-ring for ease of assemblingNOTE: If new gear