2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 128Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 128

6Using side-cutters (or suitable substitute), remove the small clamp from the shaft CD021 3Using snap ring pliers, remove
each bearing ring end for assembling purposes; then remove the bearing ringNOTE: The recess of the bearing must face toward
the housing 8Apply 40 grams (13 of contents) of grease from the grease pack included in Front Axle Boot Repair Kit (pn 0436-276)
into the knuckles and the new outside boot 5Inspect the splines of the shaft, the bearing ring, and the housing for damageNOTE:
If any damage is apparent to the splines, the bearing ring, andor the housing, the drive axle must be replaced as an assemblyATV-1052