2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 130Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 130

! CAUTION The bearing ring must go onto the shaft with the side without splines facing toward the small clamp of the inner
install the circlipNOTE: Pull the bearing ring out of the housing until it contacts the circlip; then slide the ring in half
wayThis will purge air from the housing and ensure the bearing is packed properly 2Swing the knuckle up and onto the drive
axle; then place the knuckle into place in the upper A-armSecure the knuckle to the A-arm with cap screw and new lock nutTighten
to specifications3Place the hub into position on the axle followed by hex nutTighten the hex nut finger-tight at this time4Tighten
the hub hex nut (from step 3) to specifications; then install and spread new cotter pin making sure each side of the pin