2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 131Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 131

INSTALLING FRONT DRIVE AXLE 1Position the drive axle in the gear case and steering knuckle; then insert the ball joints into
then install and spread new cotter pin making sure each side of the pin is flush to the hub nut Rear Gear Case REMOVING NOTE:
Release the cargo box latch and allow the cargo box to tilt back; then remove the cargo box lift support by removing the
cap screw and nut securing the lower lift support to the frameThe cargo box will tilt fully rearward 1Remove both of the
rear drive axles (see Drive Axles in this section)2Scribe match mark on the rear input drive flange and the rear input yoke
flange; then remove three cap screws securing the flanges together 7Install the wheel and tighten to specifications8Remove
the vehicle from the support stand9Check the front differential lubricant level and add lubricant as necessaryPR211A 3Remove