2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 132Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 132

Hub REMOVING 1Secure the vehicle on support stand to elevate the wheel; then remove the wheelNOTE: Removing or tightening
it to the frame with cap screws and lock nutsTighten to specificationsNOTE: If new gear case is being installed, tighten
the cap screws to 5.1-6.3 kg-m (37-45.5 ft-lb) 2Remove the cotter pin from the axleNOTE: During assembly, new cotter pins
should be installed 2Align the scribed match marks on the rear input drive coupler flange and the rear input yoke flange;
then install three cap screws and tighten to specifications 3Remove the flange nut securing the hub4Remove the brake caliper
(front only) 3Install the rear drive axles (see Drive Axles in this section)4Install the drive-line brake caliper and tighten
the mounting cap screws to specifications; then adjust the parking brake (see Parking Brake in Section 2)PR243A 5Remove the