2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 133Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 133

6Remove the four cap screws securing the brake disc (front hub only) PR252A INSTALLING CLEANING AND INSPECTING NOTE: Whenever
cracks or warping4Inspect the hub for pits, cracks, loose studs, or spline wearREPLACING WHEEL STUDS To replace wheel studs,
use the following procedure1Secure the hub in suitable holding fixture and remove the brake disc (if applicable)2Drive the
damaged stud out of the hub; then place the new stud into the hub and thread on an appropriate flange nutPR254B 3Install
the hub assembly onto the axle; then set the parking brake 4Secure the hub assembly with the nutTighten to specifications;