2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 136Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 136

Universal Joints REMOVING NOTE: The four universal joints can be accessed by removing the belly panelTo remove the belly
the propeller shaft flange to the yoke flange on the appropriate drive-line; then remove the propeller shaft 5Using suitable
socket and ratchet handle, rotate the jackscrew to push the bearing cup out of the yoke; then remove the tool and the bearing
cup 6Install the separator tool on the opposite side of the yoke to push the second bearing cup from the yoke; then remove
the tool and separate the universal joint7Secure the separator tool in vise and repeat steps 4-6 to remove the bearing cups