2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 143Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 143

6Install the knuckle assembly onto the ball joints and secure with cap screwsTighten to specifications PR377B 11Secure the
the vehicle from the support standAF618D 8Apply grease to the hub and drive axle splines; then install the hub assembly onto
the drive axle Rear A-Arms REMOVING 1Secure the vehicle on support stand to elevate the wheels ! WARNING Make sure the vehicle
is solidly supported on the support stand to avoid injury 2Set the parking brakeCD009 3Remove the wheel4Remove the cotter
pin securing the hex nut; then remove the hex nut 9Secure the hub assembly with the nutTighten only until snug10Secure the