2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 144Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 144

5Remove the cap screws and lock nut securing the shock absorber to the frame and lower A-arm; then remove the shock absorber6Remove
the axle out of the knuckle and set aside8Remove the cap screws and lock nuts securing the knuckle to the A-armsDiscard the
lock nuts 5Secure the hub assembly with the nutTighten to specifications6Install new cotter pin and spread the pin to secure
the nutPR220A NOTE: Never reuse lock nutOnce lock nut has been removed, it must be replaced with new lock nut 9Remove the
cap screws and lock nuts securing the A-arms to the frame; then remove the A-armsCLEANING AND INSPECTING NOTE: Whenever part
is worn excessively, cracked, or damaged in any way, replacement is necessaryPR196 1Clean all A-arm components in parts-cleaning
solvent2Inspect the A-arm for bends, cracks, and worn bushings 7Secure the shock absorber to the frame with cap screw and