2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 149Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 149

2Inspect the tie rods for bends or deformation3Inspect the rack and pinion-to-tie rod boots for tears or deterioration PR309
then secure with the two cap screws, washers, and nutsTighten to specifications ! WARNING Allowing the lower steering shaft
joint to extend too far onto the pinion shaft could cause binding or lock-up of the steering joint resulting in loss of steering
control 4Tighten the cap screw to specifications; then check that the steering wheel turns freely5Install the tie rod ends
into the steering knuckles; then secure with the castle nuts tightened to specifications6Install the cotter pins and spread
to secureNOTE: If the holes in the tie rod ends don't align with the slots in the castle nuts, tighten the nuts sufficiently
to install the cotter pins 2With the rack and the steering wheel centered, slide the lower steering shaft joint onto the