2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 150Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 150

Steering Wheel REMOVING 2Install the steering wheel aligning the two match marks; then apply drop of red Loctite #271 to
wheel cover and secure with the existing hardwareDo not over-tighten Steering Wheel Shaft REMOVING 1Remove the steering wheel
(see Steering Wheel in this section)2Remove the six torx-head screws securing the dash panel to the frame and one cap screw
and nut from the center supportPR324A 2Remove the nut securing the steering wheel and remove the steering wheelAccount for
the flat thrust-washer and two wave washers INSPECTING 1Inspect the steering wheel for cracks, missing padding, or broken
spokes2Inspect the splines for wear3Check that the steering wheel is not bentINSTALLING 1Place the flat thrust-washer and