2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 151Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 151

3Align the match marks on the steering wheel shaft and the steering wheel and slide the steering wheel onto the splines;
the steering wheel cover7Move the dash panel into position and secure to the frame and center support with the existing hardware
INSPECTING 1Inspect the steering wheel shaft for excessive wear2Check for worn splines, cracks, or damaged threads3Roll the
steering wheel shaft on flat surface to check for bends4Inspect the nylon bushings in the steering shaft housing for cracking
or excessive wearINSTALLING 1Slide the steering wheel shaft into the steering housing; then with the lower thrust-washer
in position, align the match marks and slide the upper steering shaft joint onto the steering wheel shaftPR475A 2Apply green
Loctite #270 to the cap screw; then install the cap screw in the upper steering shaft jointInstall the nut and finger-tighten