2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 153Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 153

INSTALLING 1Place the steering shaft assembly into position through the opening in the splash panel ! WARNING Allowing the
the pinion shaft and the lower steering shaft joint; then slide the steering shaft joint onto the pinion shaft 5Apply green
Loctite #270 to the cap screw; then install the cap screw in the upper steering shaft joint and finger-tighten 3Apply green
Loctite #270 to the cap screw; then secure the lower steering shaft joint to the pinion shaft making sure the pinion shaft
does not protrude into the joint beyond the clamping surfaceTighten to specificationsPR310 6Install the flat thrust-washer