2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 154Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 154

Steering Knuckles REMOVING AND DISASSEMBLING 1Secure the vehicle on support stand to elevate the wheel; then remove the wheel
the steering wheel nut for specified torque value Make sure the vehicle is solidly supported on the support stand to avoid
injury 2Remove the cotter pin from the axle3Remove the nut securing the hub4Remove the brake caliper5Remove the hub assembly6Remove
the cotter pin from the tie rod end and remove the tie rod end from the knuckle7Remove the two cap screws securing the ball
joints in the knuckle 10Place the dash panel into position and secure to the frame and center support with the six torx-head