2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 155Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 155

2Install the knuckle to the upper and lower ball joints and secure with the two cap screwsTighten to specifications PR289
breaks, or galling of the bearing surfaceASSEMBLING AND INSTALLING 1Using suitable press and driver, press the bearing into
the knuckle until firmly seated; then install the snap ring 3Install the tie rod end and secure with the nutTighten to specifications;
then install new cotter pin and spread the pinNOTE: During assembling, new cotter pins should be installed 4Apply small amount