2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 156Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 156

6Secure the hub assembly with the nutTighten to specifications 9Install the wheel; then using crisscross pattern, tighten
between the marks at the front and rearThe front measurement should be 6-12 mm (14-12 in greater than the rear measurement
(toe-out) NOTE: If the hole in the axle shaft does not align with the slots in the castle nut, tighten the nut until the
hole and slots align To adjust the wheel alignment, use the following procedure1Center the steering wheel; then using an
open-end wrench to hold the tie rod ends, loosen the right-side and left-side jam nuts 8Secure the brake caliper to the knuckle