2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 157Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 157

Front Bumper Assembly (XT) REMOVING To remove the front bumper assembly, remove four cap screws and nutsAccount for four
or tightening the jam nuts or damage to the boots could occur 2Turn the left-side and right-side tie rods in equal increments
to achieve the proper toe-out; then tighten the jam nuts securely 1Clean all bumper components with parts-cleaning solvent2Inspect
all welds for cracking or bendingINSTALLING To install the front bumper assembly, place the bumper assembly into position