2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 158Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 158

2Loosen but do not remove the four cap screws and flange nuts securing the hood hinge to the frame; then lower the hood
solvent and soap and water2Inspect the hood for cracks andor loose fasteners3Inspect for any missing decalsINSTALLING To
remove the fenders, remove three torx-head screws securing each fender to the frameAccount for stiffener bracket on the front
fenders 1Place the hood into position on the vehicle; then install the two outside cap screws and flange nutsFinger-tighten
only at this time2Open the hood; then install the remaining two cap screws and flange nutsTighten all four securelyPR311A