2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 161Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 161

INSTALLING 1With the help of an assistant or an adequate lift, set the cargo box into position on the frame; then position
are approximately 6.1 (20 ft) from an aiming surface (wall or similar aiming surface)NOTE: There should be an average operating
load on the vehicle when adjusting the headlight aim ! WARNING Do not operate the vehicle unless the headlight beam is adjusted
properlyAn incorrectly adjusted beam will not provide the operator the optimum amount of light 2Measure the distance from
the floor to the mid-point of each headlight3Using the measurements obtained in step 2, make horizontal marks on the aiming
surface4Make vertical marks which intersect the horizontal marks on the aiming surface directly in front of the headlights5Switch
on the lightsMake sure the HIGH beam is onDO NOT USE LOW BEAM6Observe each headlight beam aimProper aim is when the most
intense beam is centered on the vertical mark cm (2 in below the horizontal mark on the aiming surface Taillight Assembly