2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 164Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 164

Master Cylinder Assembly NOTE: The master cylinder is non-serviceable component; it must be replaced as an assembly REMOVING
rod and clevis for wear, bending, or elongation of clevis holes2Inspect the push rod boot for tears or deteriorationAF637D
2Remove the cotter pin and pivot pin from the yoke; then remove two cap screws and flange nuts securing the master cylinder
assembly to the frame 3Inspect the reservoir for cracks and leakage4Inspect the brake hose for cracks and deterioration and
the condition of the banjo-fittingsINSTALLING 1Place the master cylinder into position; then using three new crush washers,
secure the two banjo fittings to the master cylinderTighten to specifications (see Section 10)2Secure the master cylinder