2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 165Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 165

Accelerator Pedal REMOVING To either engage or disengage the front wheels, move the switch to the 4WD position or to the
the DIFF LOCK toggle in ADJUSTING CABLE INSTALLING To install the accelerator pedal, align the mounting holes with the holes
in the splash panel and secure with the two torx-head screws and nuts; then snap the throttle cable holding grommet into
the actuator arm 1With the toggle in the pushed-in position, slide the rubber protector sleeve (A) off the cable near the
toggle; then loosen the jam nut (B) and turn the cable adjuster (C) to achieve 3-4 mm (0.12-0.16 in free-travel measured
at the toggle 2WD4WD Selector The automatic drive selector allows the operator to operate in either 2-wheel drive (rear wheels)
or 4-wheel drive (all wheels)For normal riding on flat, dry, hard surfaces, 2-wheel drive should be sufficientIn situations