2007 Arctic Cat Y-12 90cc ATV Service Manual, Page 13Get this manual

2007 Arctic Cat Y-12 90cc ATV Service Manual, Page 13

4There should be approximately mm (0.25 in free-play in the cable5Tighten the jam nut to secure the adjustment; then slide
idle RPM 2Turn the idle adjustment screw in or out until the engine idles at 1700 RPM 3Remove the drain plug from the bottom
of the transmission and drain the lubricant into drain pan ! WARNING Adjust the idle to the correct RPMMake sure the engine
is at normal operating temperature before adjusting the idle RPM 4Install the drain plug and tighten to specifications (see
Section 10)Pour the recommended lubricant in the filllevel holeInstall the levelfill plug5Start the engine (while the ATV
is outside on level ground) and drive it short distance6Turn the engine off and wait approximately one minuteRemove the levelfill