2007 Arctic Cat Y-12 90cc ATV Service Manual, Page 19Get this manual

2007 Arctic Cat Y-12 90cc ATV Service Manual, Page 19

NOTE: The gasket does not need to be removed unless it is being replaced or unless additional servicing is being done requiring
sight glass to make sure there is always sufficient amount of brake fluid in the reservoirFailure to maintain sufficient
amount of fluid in the reservoir will result in air being in the system 5Repeat step until the brake lever is firm INSTALLING
Replacing Drive Belt REMOVING 1If removed, place the gasket and two alignment pins into position on the crankcase2Spread
the faces of the driven clutch with suitable pry bar or wedge; then when the faces are separated, insert the drive belt 1Remove
the eight Phillips-head cap screws and four cap screws securing the footrest cover to the footrest and front and rear fenders;