2007 Arctic Cat Y-12 90cc ATV Service Manual, Page 63Get this manual

2007 Arctic Cat Y-12 90cc ATV Service Manual, Page 63

9Remove the two cap screws securing the gas tank; then lift the gas tank and secure it out of the way 3Inspect gas tank cap
fender panel with the eight washers, four Phillips-head cap screws, and six nuts and tighten to specifications (see Section
10)NOTE: Do not over-tighten the cap screws and nuts securing the front fender panelMD1848 4Install the gas tank cap5Install
the handlebar aligning the pins in the lower clamps with the locating holes in the bottom of the handlebarPlace the top clamps
into position; then tighten the cap screws to specifications (see Section 10) CLEANING AND INSPECTING NOTE: Whenever part