2007 Arctic Cat Y-12 90cc ATV Service Manual, Page 67Get this manual

2007 Arctic Cat Y-12 90cc ATV Service Manual, Page 67

2Connect the red tester lead to the blackyellow wire; then connect the black tester lead to the green wire3Crank the engine
Connector) 1Set the meter selector to the DC Voltage position; then turn the ignition switch to the ON position2Connect the
red tester lead to the greenyellow wire; then connect the black tester lead to suitable ground3The meter must read battery
voltageNOTE: If the meter reads no battery voltage, troubleshoot the battery, fuse, switch, or the main wiring harnessNOTE:
If the meter reads battery voltage, the main wiring harness is good; test the switchcomponent, the connector, and the switch
wiring harness for resistance 1Set the meter selector to the OHMS position2Connect the red tester lead to the yellow wire;
then connect the black tester lead to the white wire3The meter must less than ohm Choke Circuit Disconnect the white two-pin
connector adjacent to the steering postCHOKE VOLTAGE NOTE: The battery must be at full charge for this test RESISTANCE (Brakelight