2007 Arctic Cat Y-12 90cc ATV Service Manual, Page 68Get this manual

2007 Arctic Cat Y-12 90cc ATV Service Manual, Page 68

3When the lever is compressed, the meter must read less than ohmNOTE: If the meter reads more than ohm of resistance, troubleshoot
read less than ohm resistanceIf the meter reads open, replace the fuseNOTE: Make sure the fuse is returned to its proper
position according to amperage Ignition Switch The connector is accessible below the front fender panel in front of the steering
postVOLTAGE NOTE: Perform this test on the harness side of the connector Ignition Coil The ignition coil is attached to the
upper frame behind the left-side of the front fender panelThe coil can be accessed inside the front-left fender well 1Set
the meter selector to the DC Voltage position2Connect the red meter lead to the red wire; then connect the black meter lead
to suitable ground3Meter must read battery voltageNOTE: If the meter reads no battery voltage, troubleshoot the battery,
fuse, or the main wiring harness ! CAUTION Always disconnect the battery when performing resistance tests to avoid damaging
the multimeter NOTE: For these tests, the meter selector should be set to the OHMS position PRIMARY WINDING RESISTANCE 1Disconnect