2007 Arctic Cat Y-12 90cc ATV Service Manual, Page 69Get this manual

2007 Arctic Cat Y-12 90cc ATV Service Manual, Page 69

3Connect the red tester lead to the red wire; then connect the black tester lead to the greenyellow wire4The meter must read
Magneto Assembly REMOVING Handlebar Control Switches The connector is in front of the steering postThe connector is accessible
beneath the front fenderNOTE: These tests should be made on the switch side of the connector 1Disconnect the battery ! CAUTION
Always disconnect the negative battery cable from the battery first; then disconnect the positive cable 2Remove the flywheel
from the engine (see Section 3)3Remove the stator and timing sensor from the stator plateINSPECTING ! CAUTION Always disconnect
the battery when performing resistance tests to avoid damaging the multimeter RESISTANCE (Starter Button) 1Check stator for
signs of overheating, broken wires, or other damage2Check the timing sensor for broken wires or signs of damageINSTALLING
1Set the meter selector to the OHMS position2Connect the red tester lead to the yellowwhite wire; then connect the black