2007 Arctic Cat Y-12 90cc ATV Service Manual, Page 76Get this manual

2007 Arctic Cat Y-12 90cc ATV Service Manual, Page 76

4Remove the drive chain master link clip, link plate, and master link; then allow the drive chain to roll off the rear sprocketAccount
onto the axle and into position next to the axle housing NOTE: It is not necessary to completely remove the drive chain in
order to remove the rear sprocket 5Slide the right-side axle spacer off the axle 3Slide the right-side axle spacer onto the
axle4Install the drive chain (see Installing Drive Chain in this sub-section)5Install the chain guard and secure with two
cap screwsTighten securelyMD2365 6Install the right rear wheel and hub as unit7Install the washer and castle nutTighten the