2007 Arctic Cat Y-12 90cc ATV Service Manual, Page 77Get this manual

2007 Arctic Cat Y-12 90cc ATV Service Manual, Page 77

8Install new cotter pin AT THIS POINT If the technician's objective is to servicereplace the drive axle, the axle housing
rear wheels 2Remove the cotter pins from the castle nuts on the rear wheel hubs3Remove the rear wheel hub castle nuts; then
slide the rear wheels and hubs off togetherAccount for the washers4Remove the drive chain (see Removing Drive Chain sub-section)5Remove
the rear sprocket (see steps 5-8 of Removing Rear Sprocket sub-section)6Remove the drive axle by sliding it out the right
side of the axle housingNOTE: Note the difference in the length between the four sets of splines on the axle for installing
purposes ! WARNING Make sure the ATV is solidly supported on the support stand to avoid injury 2Remove the wheels and hubs