2007 Arctic Cat Y-12 90cc ATV Service Manual, Page 79Get this manual

2007 Arctic Cat Y-12 90cc ATV Service Manual, Page 79

2Place the center axle housing spacer in the axle housing; then using plastic mallet, install the second bearingNOTE: It
to the inside (mating surface) of the seals; then using plastic mallet, install the seals 2Slide the axle through the brake
disc INSTALLING AXLE HOUSING 1Position axle housing in swing arm; then install and finger-tighten the four cap screws securing
the axle housing to the swing arm2Install the brake caliper to the axle housingKM234 3Making sure to direct the flared end
toward the brake disc, install the left axle spacer over the axle 3Install the drive chain (see Installing Drive Chain sub-section)4Adjust