2007 Arctic Cat Y-12 90cc ATV Service Manual, Page 102Get this manual

2007 Arctic Cat Y-12 90cc ATV Service Manual, Page 102

3Install the brake cable to the lever assembly 6Remove the cover from the master cylinder and fill with DOT brake fluid;
must be bled (see Brake SystemsBLEEDING in Section 2) 4Position the left brake lever assembly onto the handlebar and secure
with the clamp and two cap screwsTighten securely NOTE: Before installing handlebar grip, use contact spray or alcohol to
clean the inside of the grip and the handlebar of adhesive residue, oil, or any other contaminant 9Apply liberal amount of
Handlebar Grip Adhesive to the inside of the grip; then slide the right grip onto the handlebarWipe off any excess adhesive10Tighten