2008 Arctic Cat 366 ATV Service Manual, Page 18Get this manual

2008 Arctic Cat 366 ATV Service Manual, Page 18

KC0077A AT THIS POINT To checkservice oil strainer, see Section 3 3Drain the oil into drain pan by removing the drain plug
threads of the plugIf low, add SAE approved 80W-90 hypoid gear lubricant as necessaryTo change the lubricant, use the following
procedure1Place the ATV on level ground2Remove each oil fill plug 737-651B 4After all the oil has been drained, install the
drain plugs and tighten to 45 inlb5Pour the appropriate amount of approved SAE 80W-90 hypoid gear lubricant into the filler
hole6Install the fill plugsNOTE: If the differentialrear drive oil is contaminated with water, inspect the drain plug, filler
plug, andor bladder ! CAUTION Water entering the outer end of the axle will not be able to enter the rear drive unless the