2008 Arctic Cat 366 ATV Service Manual, Page 19Get this manual

2008 Arctic Cat 366 ATV Service Manual, Page 19

Tires TIRE SIZES The ATV is equipped with low-pressure tubeless tires of the size and type listed (see Section 1)Do not under
or looseBHandlebar not bent, cracked, and has equal and complete full-left and full-right capabilityCSteering post bearing
assemblybearing housing not broken, worn, or bindingDBall joints not worn, cracked, or damagedETie rods not bent or crackedFKnuckles
not worn, cracked, or damagedGCotter pins not damaged or missing NutsBoltsCap Screws Tighten all nuts, bolts, and cap screwsMake
sure rivets holding components together are tightReplace all loose rivetsCare must be taken that all calibrated nuts, bolts,
and cap screws are tightened to specifications Ignition Timing The ignition timing cannot be adjusted; however, verifying
ignition timing can aid in troubleshooting other componentsTo verify ignition timing, use the following procedure1Attach
the Timing Light to the spark plug high tension lead; then remove the timing inspection plug from the left-side crankcase
cover2Using the Tachometer, start the engine and run at 1500 RPM; ignition timing should be 10 BTDC3Install the timing inspection