2008 Arctic Cat 366 ATV Service Manual, Page 20Get this manual

2008 Arctic Cat 366 ATV Service Manual, Page 20

Lights Rotate the ignition switch to the lights position; the headlights and taillights should illuminateTest the brakelights
fingerprints or other contaminates on the glass; then secure with the spring ! WARNING Do not attempt to remove bulb when
it is hotSevere burns may result To replace the headlight bulb, use the following procedure1Remove the protective rubber
boot from the rear of the headlight housing; then remove the wiring harness connector from the back of the headlight bulb
5Connect the wiring harness connector to the bulb; then install the protective rubber boot making sure it seals completely
on the headlight harness TAILLIGHTS-BRAKELIGHTS To replace taillight-brakelight bulb, use the following procedureKC162 2Press