2008 Arctic Cat 366 ATV Service Manual, Page 21Get this manual

2008 Arctic Cat 366 ATV Service Manual, Page 21

CHECKINGADJUSTING HEADLIGHT AIM The headlights can be adjusted vertically and horizontallyThe geometric center of the HIGH
to release from light housing; then press in on the bulb and turn counterclockwise to release from the socketATV-0070C NOTE:
There should be an average operating load on the ATV when adjusting the headlight aim 2Measure the distance from the floor
to the mid-point of each headlight3Using the measurements obtained in step 2, make horizontal marks on the aiming surface4Make
vertical marks which intersect the horizontal marks on the aiming surface directly in front of the headlights5Switch on the
lightsMake sure the HIGH beam is onDO NOT USE LOW BEAM6Observe each headlight beam aimProper aim is when the most intense
beam is centered on the vertical mark cm (2 in below the horizontal mark on the aiming surface 2Install new bulb and press