2008 Arctic Cat 366 ATV Service Manual, Page 23Get this manual

2008 Arctic Cat 366 ATV Service Manual, Page 23

738-420A NOTE: During the bleeding procedure, watch the reservoir sight glass very closely to make sure there is always sufficient
the brake leverRepeat this procedure until no air bubbles are present EAt this point, perform step B, C, and on the other
FRONT bleeder screw; then move to the REAR bleeder screw and follow the same procedure4Carefully check the entire hydraulic
brake system that all hose connections are tight, the bleed screws are tight, the protective caps are installed, and no leakage
is present ! CAUTION Brake fluid that has been drained or bled from the brake system must NEVER be re-used or severe brake
system corrosion and damage may occurAlways discard used brake fluid in an appropriate manner ! CAUTION This hydraulic brake
system is designed to use DOT brake fluid onlyIf brake fluid must be added, care must be taken as brake fluid is very corrosive
to painted surfaces INSPECTING HOSES Carefully inspect the hydraulic brake hoses for cracks or other damageIf found, the