2008 Arctic Cat 366 ATV Service Manual, Page 24Get this manual

2008 Arctic Cat 366 ATV Service Manual, Page 24

1Remove front wheel2Measure the thickness of each brake pad3If thickness of either brake pad is less than 1.0 mm (0.039 in,
Failure to properly burnish the brake pads could lead to premature brake pad wear or brake lossBrake loss can result in severe
injury 1Choose an area large enough to safely accelerate the ATV to 30 mph and to brake to stop2Accelerate to 30 mph; then
compress brake lever or apply the auxiliary brake to decelerate to 0-5 mph3Repeat procedure on each brake system five timesPR237
4Adjust the auxiliary brake (if necessary)5Verify that the brakelight illuminates when the hand lever is compressed or the
brake pedal is depressed CInstall the new brake padsDSecure the caliper to the knuckle andor axle housing with the cap screwsTighten