2008 Arctic Cat 366 ATV Service Manual, Page 40Get this manual

2008 Arctic Cat 366 ATV Service Manual, Page 40

2Place the valve cover on the Surface Plate covered with #400 grit wet-or-dry sandpaperUsing light pressure, move the valve
components only, proceed to Removing Left-Side ComponentsCC130D Servicing Top-Side Components NOTE: Whenever part is worn
excessively, cracked, or damaged in any way, replacement is necessary ! CAUTION Water or parts-cleaning solvent must be used
in conjunction with the wet-or-dry sandpaper or damage to the sealing surface may result Removing Valves NOTE: Keep all valves
and valve components as setNote the original location of each valve set for use during installationReturn each valve set
to its original location during installation VALVE ASSEMBLY When servicing valve assembly, inspect valve seats, valve stems,
valve faces, and valve stem ends for pits, burn marks, or other signs of abnormal wearNOTE: Whenever valve is out of tolerance,
it must be replaced 1Using valve spring compressor, compress the valve springs and remove the valve keepersAccount for an