2008 Arctic Cat 366 ATV Service Manual, Page 48Get this manual

2008 Arctic Cat 366 ATV Service Manual, Page 48

MD1343A 2If damaged, the camshaft must be replaced ! CAUTION Incorrect installation of the piston rings will result in engine
not overlapStagger the end gaps of the upper and lower thin oil rings according to the illustration 2Place the two alignment
pins into positionPlace new cylinder gasket into position; then place piston holder (or suitable substitute) beneath the
piston skirt and square the piston in respect to the crankcase ATV-1085B NOTE: Note the direction of the exhaust side of
the piston (5) for correct ring end gap orientation BInstall the compression rings (1 and 2) so the letter(s) on the top
surface of each ring faces the top of the pistonRotate the rings until the ring end gaps are on directly opposite sides of