2008 Arctic Cat 366 ATV Service Manual, Page 52Get this manual

2008 Arctic Cat 366 ATV Service Manual, Page 52

27Install the four top-side cap screws with rubber washers; then install the remaining cap screwsTighten only until snug
plug Left-Side Components 25Loosen the adjuster screw jam nuts; then loosen the adjuster screws on the rocker arms in the
valve cover26Apply thin coat of Three Bond Sealant to the mating surface of the valve cover; then place the valve cover into
positionNote that the two alignment pins are properly positionedNOTE: At this point, the rocker arms and adjuster screws
must not have pressure on them NOTE: For efficiency, it is preferable to remove and disassemble only those components which
need to be addressed and to service only those componentsThe technician should use discretion and sound judgment AT THIS
POINT To service any one specific component, only limited disassembly of components may be necessaryNote the AT THIS POINT